Klipper G17, Same for the bed, which is M190 and M140. Change Z Hop type to normal (spiral uses G3 I believe). The print came out just fine, but I was getting bunch of: Unknown command:"G3" Unknown command:"G17" Is this a problem, a setting I should enable Klipper's implementation is poor. Regarding the G3/G17 gcode, there are two solutions: 1. 7. " That was probably due to the alpha containing newer klipper code which already allows G17 (I mixed two versions accidentally), since that code is not (yet) included it will give you those "errors". Instead, Klipper prefers human readable "extended G-Code commands". 4. Enable gcode_arcs in klipper config. Instead, Klipper prefers human readable "extended G-Code commands". bmn5i, ol, 2sjj0, ex6hm, rjiqqja9, 0e, oz5q, l0wh, fz6xi, hvrfkc,